Part Description
Daytona, speed pulse converter twin signals output universal
Installs on top of the stock mechanical speedo drive cable and is M12 threaded. The converter-sensor sends electronic pulses, allowing you to run an electronic speedometer on a bike with a mechanical driven speedo drive. The sensor requires 12V and connects with three 120cm wires, current, signal and ground. The speedometer will require calibration. The stock mechanical speedometer can still be used, when desired, but when not in use the included cap can be installed to weatherproof seal the drive/converter unit. Wire length 650mm. Maximum dimensions of the inner square cable diameter 2.54mm.
