19.30 19 Transmission Case Shifter Seal Installer These two simple tools make installing the shifter shaft seal precise and effortless. They align, center and install the shifter seal to the right depth on all EVO and Twin Cam Big Twin & Sportster models. 619299 Use to install H-D seal No.3710184B, 11000101 on 06-23 6-speed transmission and 84-05 Sportster 619300 Use to install H-D seal No. 12045 on all EVO Big Twins 80-99 or on H-D Twin Cam 5-Speed 99-06 FXST, FLH and FXD -05. Jims Ignition Alignment Tool The professional technician needs fast and accurate alignment of the ignition switch cover. Fiddling with screwdrivers and coat hangers does not cut it! Our alignment tool is the perfect solution; correct alignment is quickly and easily achieved. This tool is for 2014 and later touring models and based on our proven design for earlier models. 642290 Alignment tool for 14-23 HDI Touring models JIMS Outer Balancer Bearing Installer & Remover Tool This tool removes and installs the outboard balancer bearing on the new 96” and 110” “B” Softail engine’s chain guide support plate. Sold each. 622056 For all Softail models 07-17 JIMS Ignition Switch Housing Alignment Tool This tool will easily align the ignition switch housing as the retaining screws are being torqued. This gives the ignition switch knob the alignment it needs to help extend the life of the ignition switch housing. Sold each. 622051 For all FL models 03-13, V-Rod models 02-17 622051 FXST Rear Seat Mounting Screw Tool The JIMS tool locates on the seat screw head to keep from scratching or damaging the rear fender, or screw, when installing or removing the seat. 619301 Use on 07-23 Softail models using the H-D screw No. 3075 Jims Angled Feeler Gauge This new innovative feeler gauge holder eliminates the need to use bulky multi feeler gauge tools while performing valve adjustments. This tool is ideal for reaching down into small tight areas and incorporates an angle to help reach around corners, often necessary for adjusting valves. Tool includes two handles with: .002”, .003”, .004”, .005”, .006” and .008” inserts. 619304 Feeler Gauge Kit JIMS Balancer Shaft Removal Tool This tool is designed to remove both front and rear counter-balancer shaft bearing assembly from the left engine case on the new 96” and 110” Beta engines. Sold each. 622058 For all Softail models 07-17 JIMS Twin Cam Timken Case Bearing Conversion Tool This tool is a must for the big cubic inch late model Twin Cam engine builder. It may also be used to replace bearing for stock 88" or 96" engines. Utilizing the special JIMS precision insert, it is designed to easily and accurately convert the left side crankshaft roller bearing (H.D. No.24604-00D) to the more durable Timken Bearing (H.D. No.9028). This insert is manufactured from aluminum that is several times stronger than the aluminum case material the standard bearing rides in. The Tool Includes: • A new steel bearing insert held to under .0002” TIR (total indicator reading). • A press plate that will hold the bearing insert in line with the case bearing bore at the time it is being pressed into case. • All the necessary drill bits to drill oil feed and return holes, hardware, and detailed instructions. This job can be performed with normal hand tools, a hand drill, and a 2 ton press. *Order Bearing Inserts & Timken Bearings separately. 640097 Tool for use on Twin Cam engines 03-17 640098 Stainless steel Timken case bearing insert kit
RkJQdWJsaXNoZXIy ODQ0NDEw