19.34 19 JIMS Piston Ring Compressor Extra fine tooth ratcheting mechanism will compress rings in small increments without breaking. Includes six bands ranging from 2 7/8" to 4 3/8". 400357 JIMS Cam & Pinion Gear Gauge Pins Use to check gear diameters when changing cams or pinion gears on single cam Big Twins ONLY. Sold in pairs. 400362 Fits Big Twins from 54-89 (.105" pins) 400363 Fits Evolution Big Twins from 90-99 (.108" pins) JIMS Wrist Pin Bushing Tool Makes it easy to remove and install rod bushings on all models (except Twin Cam 88 models). Complete instructions guide you through removal, selection of new bushing with the proper clearances, and installation. 20169 Fits all Single Cam Big Twins up to 99. Fits 57-20 Sportster, 95-02 Buell and 45” Flathead. JIMS Wrist Pin Remover Tool This simple tool can be used easily by one person. No need to get another technician to hold the piston while your drift the pin out. (99-06 Twin Cam) 20287 99-06 Twin Cam (except 06 Dyna) JIMS Piston Pin Keeper Tool Makes piston pin retaining ring installation a snap. Fits stock piston pin retainers on Big Twins from 83-99 (except Twin Cam 88 models) and Sportster models from L85-20, 87-10 Buell (exc. 1125). 20674 Sold each JIMS Wrist Pin Bushing Tool Removes and replaces the wrist pin bushing without removing the connecting rod from the crankcases. 20295 For Twin Cam 88 models from 99-06 Connecting Rod Clamping Tool Holds rod when fitting piston pin bushing. Used on all V-twin models (repl. OEM 95952-33). Sold each. 400548 Connecting Rod Clamping Tool Cam Gear Gauge Pins These pins are used to properly determine cam and pinion gear sizes. Sold in pairs. 24196 0.105"-diameter BT 54-89 Clear Long Timing Plug Tool 894888 Fits Big Twin 70-98 Piston Ring End Gap Tool • Accurate tool to measure ring end gap faster • The flanged design allows the piston ring to fit squarely in cylinder bore every time • Each side of the tool is made for checking a standard size piston rings • For Twin Cam standard size pistons for 95” 103” or 110”, with 3.875” or 4.000” bore 890574 Piston ring end gap tool Piston Jet Test Stand If you plan to rebuild more than two Twin Cam engines and or lower ends - this tool pays for itself! • Clear the jet of all assembly lubes • Verify the PSI number the jet switches “on” • Visualize the spray pattern • For Twin Cam 99-17 890569 Piston jet test stand
RkJQdWJsaXNoZXIy ODQ0NDEw