19.36 19 622181 622180 JIMS Oxygen (O2) Sensor Wrench This tool is a must for removing and installing H-D’s new 4 wire heated Oxygen Sensors. The new fragile O2 sensor must be torqued to 14 ft-lbs, lending to the design of this tool to be used with a 3/8” drive torque wrench. 622187 Use on 12-17 Dyna, 12-17 Softail, 10-16 Touring 622187 Oxygen Sensor Socket Tool This tool is used to remove or install the oxygen sensor on all closed loop fuel injected H.D. models. Socket has a 3/8" drive receiver or can be used with a 7/8" wrench. Socket will withstand up to 125 ft/lbs of torque. 640091 For use on all EFI models 06-11 (except 10- touring) JIMS Head Bolt Torque Gauge for Evolution Engines Allows the measuring of 90° when tightening head bolts. Torque sequence laser-etched on gauge. 20805 For all Twin Cam, Evolution and Sportster engines from 84-17 JIMS Exhaust Stud Drill Plate Guides and aligns the drill bit when removing broken exhaust studs. Use with a tap after to clean the threads. Can be used in the frame. Includes drill bit. 20940 For Evolution and Twin Cam models JIMS Pushrod Cover Clip Installing and Remover Tool Made from black delrin, this tool will NOT marr or slip – and will install the clip professionally with just one hand in seconds! It’s a luxury tool that you will appreciate for years to come. 622184 Use on all V-Twins that use pushrod clips.Ç Valve Guide Driver Set 3 piece driver set for valve guide installation and removal on Big Twin and Sportster models. Includes drivers for 5/16", 11/32", and 3/8" I.D. guides. 400562 JIMS Exhaust Gasket (Seal) Installer Tool No longer do you need to fight trying to install this fragile exhaust seal. You’ll never worry about an exhaust leak again. Tool can be used with exhaust flange nuts, or JIMS handle CCI No. 20666 sold separately. Either way will position the seal evenly into the exhaust port of head. 622182 Use on all 84-23 EVO Big Twins, XL, and all Twin Cam models, Milwaukee Eight JIMS Top Center Case Bolt Spot Facer Tool Added insurance when building a big bore Twin Cam engine. You have seen the center right case bolt thread that has become compromised from the larger cylinder spigot bore diameter? Now you can get back all the necessary case bolt retention by installing one of JIMS Through Bolts Kits. This tool is needed to spot face the right case so the bolt head will seat flat on the case surface. Use on all Twin Cam 99-17. 622180 Case Bolt Spot Facer Tool 622181 Center Through Bolt Kit JIMS Valve Spring Compressor Designed specifically for the heads on Evolution models, but will work with all Big Twins. It features a hardened ball bearing at the valve head end to eliminate damage to valves. Comes with new valve collar receiver for safer tool usage. 20696 For all Evolution Big Twin and Sportster engines Valve Spring Compressor Tool Use this collar with CC #20696 to remove and replace valves and conical (beehive) springs. A must-have tool for safe valve work. 622039 Fits all 04-20 Sportster, 05-17 Twin Cam and 04-10 Buell models, except CVO models
RkJQdWJsaXNoZXIy ODQ0NDEw