19.38 19 Tappet Guide Puller for Sportster Models Removes press-fit tappet guides from the crankcase after tappet body adjusting screw is removed. Fits Sportster models from 57-78. 20104 Replaces OEM 95724-57 JIMS Flywheel Timken Bearing Remover Used to remove Timken bearings from sprocket shafts without re-moving shafts from the flywheels. 22303 Fits stock flywheels on Big Twins from 86-02 20459 Fits stock flywheels on Big Twins from 55-85, and aftermarket flywheels from 55-02 22303 JIMS Sprocket Shaft Tools For installing the crankshaft into the crankcase Timken bearing. For Big Twin Models 20116 Fits Big Twins from 55-02 Sprocket Shaft Seal Tool Used with CC #20116 to press oil seal over sprocket shaft into the case. 20687 Fits Big Twins from 70-11 JIMS Snap Ring Installation and Removal Tool Removes and installs the Timken bearing outer race snap ring. A must for replacing rings in cases without inserts. No more gouging the aluminum surrounding the snap ring. 20943 Fits Big Twin models from 69-02 JIMS Drill Jigs for Precision Bushing Dowel Pin Location These drill jigs ensure exact factory bushing dowel pin location when building performance engines. Supplied with jig and drill bit. 20623 For pinion bushings on Big Twins from 54-92 Motion Pro Tappet Tool Removes and fastens the tappet oil filter screen cover without removing exhaust on some models, and avoid scratching your engine cases. Sold each. • Includes O-ring to retain it in a 7/16" wrench or socket drive • Hex 7/16" drive allows more rotation before contacting cases • Flange design allows downward force to be applied to tool • The tappet oil filter screen is required to be serviced at every oil change • Fits all Big Twins (except Twin Cam 88) with slotted screw tappet oil filter screen cover 640110 Tappet Tool 20727 20666 JIMS Rod Lapping Tool Fits Big Twins, Sportster and K models, 45" and Indian rods (except Twin Cam 88 models). Includes arbor assembly, 1.500" lap for 45", Indian and some case races. 1.625" lap for Big Twin, Sportster and K model rods. 26409 Lapping tool JIMS Sprocket Shaft Bearing Race Tools Bearing Race Remover and Installation Tool With Race Tool Spacer Use with bearing driver tools to apply outward pressure to grip the race for easier installation and removal. 20727 For CC #20688 and #20689 - For 73-99 Big Twin, Sportster and 87-99 Buell. Sold each. Sprocket Shaft Bearing Race Tool for Big Twins Used to remove and install Timken bearing race in motor case. 20688 Fits Big Twins from 69-02 Sprocket Shaft Bearing Tool for Sportster Models Used with to remove and install Timken bearing race in motor case. 20689 Fits 77-03 Sportster, 87-03 Buell models Driver Handle Handle for bearing drive tools. 20666 Driver Handle JIMS Flywheel Sockets Low profile, yet provide 100% nut coverage. The socket end is machined flat to eliminate rounding-off the flywheel nut. Made from 4130 chrome-moly and heat-treated for strength. 20634 1 5/8" x 3/4" drive for sprocket shaft nut on Big Twins from 72-99 (except 99 Twin Cam)
RkJQdWJsaXNoZXIy ODQ0NDEw