19.40 19 JIMS Wrist Pin/Rod Alignment Tool Checks rod straightness without removing rods from case. Measures 4 1/2"-long. 20298 Fits all single cam Big Twins ONLY (including aftermarket and S&S) Rod Alignment Tool • Use to check rod straightness without removing rods from case • The alignment tool is 4-1/2” long • Use on all Twin Cam A and B (Includes aftermarket motors) • .927” Wrist Pin 890573 Rod Alignment tool Clutch Adjuster Nut Tool by Motion Pro • For use on all 98-17 Big Twin models excluding applications with hydraulic clutches • Deep socket allows tool to recess into clutch basket and can be driven with 11/16” combination wrench or adjustable wrench • Through hole allows access with hex wrench to hold clutch adjuster screw while simultaneously tightening the adjuster lock-nut • Heavy duty tool for shop or home use • Compact design fits easily in the saddle bag or tool roll 641128 Clutch Adjuster Nut Tool JIMS H-D Cruise Drive 6-Speed Maindrive Gear and Bearing Remover / Installer Kit Complete Kit for servicing the main drive gear or the main bearing on the latest H-D 6-speed transmission. Removes or installs both parts correctly without damaging the case. 622057 All Twin Cam H-D 6-Speed Cruise Drive models, 06-17 Dyna's and all 07-17 Twin Cam models Flywheel ‘Jam’ Tool Holds the crankshaft in the TDC (topdead-center) position when installing cams. It threads into the cases in place of the timing hole plug and permits you to snug it up to the flywheels with the timing mark showing through its hollow center. It was designed for use on Sportster engines which have a tendency to rotate past TDC when changing cams, but it may also be used on Big Twins. 20188 Sold each JIMS H-D Cruise Drive 6-Speed Maindrive Gear Remover Tool Removes the main drive gear from the main bearing correctly while in the transmission case. Eliminates the need of an arbor press and the risk of case damage 622054 Fits all 6-speed 06-17 Twin Cam and 17-23 M8 models JIMS Starter Jackshaft Seal Installer Tool This tool is designed to easily align and install the starter jackshaft seal (H-D No.12066) without distorting or damaging the seal. This seal is located in the upper part of the inner primary of Big Twins. Sold each. 622059 For all Twin Cam FL models 99-06, FXST models 00-06 & FXD models 99-05, and on all Big Twin EVO 94-00 Mainshaft Mainshaft Seal Remover The Milwaukee Eight has a new crankshaft oil seal that is difficult to remove without potentially damaging the crankcase bore. This new unique and exclusive JIMS tool is designed to do the job right, with no chance of damage to the case. Simply insert the removal fingers over the engine output shaft, and then slide the lock collar over the fingers. Once assembled, you can easily remove the seal square to the bore by simply turning a wrench. Part#: 917608 , Fitment: 17-23 Touring, 18-23 Softail, 17-23 Trike , Unit: Each , Qty.: 1 JIMS Inner Primary Cover Bearing and Seal Installer/ Remover Tool Designed to safely remove and install the inner primary bearing, (H-D No.9135) without any damage to the new bearing. This is done by pushing on the outer perimeter of the bearing. Also removes and installs inner primary seal, (H-D No.12052A). This is the bearing and seal that the transmission mainshaft passes through. Sold each. 622060 For all Late 84-05 Softail models, 85-06 Touring models and 85-05 FXR & Dyna models
RkJQdWJsaXNoZXIy ODQ0NDEw