19.47 for more details check www.custom-chrome-europe.com APPAREL HAND CONTROLS LIGHTING ELECTRICAL EXHAUST INTAKE ENGINE GASKETS TRANNY & CLUTCH DRIVELINE WHEELS, TIRES & BRAKES FRAMES FORKS & SHOCKS SHEETMETAL INSTRUMENTS & GAUGES LUBRICANTS & CHEMICALS TOOLS & EQUIPMENT SEATS & TOURING FOOT CONTROLS JIMS Fork Nut Socket Stop rounding off the flats of your top fork tube plugs with this specialty socket tool. 20455 Fits all Wide Glide front forks from 48-17 Jims Fork Seal Install Tool Tool to install fork seals on all models equipped with 49mm forks 02-23 682594 Seal install tool Adjustable Split Fork Seal Driver Set by K&L Supply Replace fork seals without removing the inner fork tube from the T-clamp. Set includes: one Split Seal Driver and three Seal Guides 35mm, 39mm, 41mm. 400349 Fork Seal Installer. Use on 35mm, 39mm, and 41mm fork tubes Fork Cap Fork Nut Socket • Use to remove or install top fork nut on glide forks • Has rubber protector on inside to prevent damage to chrome nut Unit: Each , Qty.: 1 PART# FITMENT 917613 84-17 Softail, except 16-17 FXSE, 14-17 FXSB, 13-14 FXSBSE, 80-85 FXWG, 93-03 FXDWG, 02 FXDWGSE3, 04-05 FXDWGI 917614 For all HD Models with a 35mm upper Fork Nut Shock Absorber Pre-Load Wrench by Progressive Suspension • Specially designed spanner wrench for use in adjusting shock absorbers on Softail models • Works left or right. Uses 3/8" socket drive • Specially designed to fit into tight spaces • Use to loosen and tighten lock nut and to adjust spring pre-load 400310 89-17 Softail JIMS 25mm Wheel Bearing Puller Tool This tool is used to remove the new front 25mm H.D. wheel bearings on most of the 07-19 ABS or non-ABS wheels. Note: This tool must be used with the current JIMS wheel bearing installer/remover tool No.1042 (CC# 400394). 640093 For use on 25mm bearing wheels 640087 25 mm wheel bearing installer JIMS Hollow Axle Plug Tool Late model Dyna and Sportsters are now using hollow axles. The use of this new hollow axle has eliminated the center point of the axle, which had been preferably used as a center point for rear tire alignment references. Lube the o-ring ends of these tools and insert in left and right ends of axle on Dyna, and Sportster models. This will give you the correct center point required for safe vehicle alignment. Sold each. 622053 For all 08-17 Dyna and 08-20 Sportster models Wheel Alignment Tool • For use on Softails, Sportster and Dyna • Proper wheel alignment extends chain/sprocket and belt life • Designed to help set rear wheel alignment • Fast, accurate and easy to use • Fast, accurate and easy to use 5008368 Wheel Alignment Tool JIMS Late Sealed Wheel Bearing Race Removal and Installation Tool Use to remove and install "new style" sealed wheel bearings without damaging the wheel. 400394 Fits 00-17 Twin Cam, 17-23 M8, 00-20 Sportster, 00-10 Buell and 15-20 Street models
RkJQdWJsaXNoZXIy ODQ0NDEw