dragspecialties.eu / partseurope.eu WINDSHIELDS & FAIRINGS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION, CLUTCH LINE & DRIVELINE ENGINE GASKETS & SEALS LIGHTING & LICENSE PLATES ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES & BRAKE LINES DASHES & GAUGES FENDERS COVERS, LOCKS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES All part numbers in BLUE are new for the OldBook. SECTION 5 See FATBOOK For Late Model Applications 268 DISCLAIMER: SEE PAGE 5 FOR IMPORTANT INFORMATION REGARDING CERTAIN WARRANTY AND EMISSION CONTROL REGULATION COMPLIANCE AND NOISE REGULATION INFORMATION. PART # DESCRIPTION KHS-020 For HSR42/45 carb on Evolution Big Twin HSR CARBURETOR HEAD-BREATHER KIT •For use with Mikuni air filter PART #HS42012250 and HS42012300 •For the installation of HSR carburetor kits using the K&N high-flow filter on Evo Big Twins PART # DESCRIPTION 1012-0218 Short leg breather kit for 93-99 Evolution Big Twin (most carbs except Mikuni HSR) 1012-0216 Long leg breather kit for 93-99 Evolution Big Twin with Mikuni HSR series carb 1012-0217 Optional catch tank for breather kits BLUEGRASS BREATHER KITS •Kit routes the vented gases upward so gravity can keep any expelled oil droplets back into the engine instead of down the sides of the bike •Vent line can be run up or out, into an optional catch tank (available separately, PART #1012-0217) •Includes vent hose and fittings 1012-0216 1012-0217 PART # DESCRIPTION DS-289620 For 93-99 Evolution Big Twin CRANKCASE BREATHER KIT •One-piece chrome tube design •Includes breather bolts, washers and hardware •Works with most aftermarket air cleaners PART # DESCRIPTION DS-289082 For all 93-99 Evolution Big Twin models DS-289060 For 93-99 Evolution Big Twin models (no hose or filter) DS-289073 Repl. filter CRANKCASE BREATHER/SUPPORT BRACKET KITS •Allows the installation of aftermarket air cleaner assemblies on late model bikes equipped with OEM CV carb •Includes bracket, filter, hose and all mounting hardware necessary for installation except where noted DS-289082 PART # DESCRIPTION DS289118 For 93-99 Evolution Big Twin custom applications only BRAIDED HOSE CRANKCASE BREATHER KIT •This kit provides the best looking alternative to black rubber hoses when mounting a crankcase breather system •Features a 3/8” ID stainless steel braided hose crimped onto chrome banjo fittings •Outlet side of assembly is long enough to custom-route the hose and mount the breather filter in an inconspicuous location •Includes breather filter (with mounting stud), hardware and instructions •Air cleaner and carb support bracket must be purchased separately NOTE: Not recommended for stock applications. Make sure the braided line does not contact anything (i.e.; the gas tank, carb or wiring) as damage may result.
RkJQdWJsaXNoZXIy ODQ0NDEw