MCS Workshop Catalog by BMG

244 OPTIMATE OPTIMATE, BATTERY CHARGE CABLE O-14 Battery clips with a 15A fuse, with ‘easy grip’ rubber handles, custom designed to fit round, square (power sport) and flat tab posts. - Length=20"/50cm - I ndustry standard SAE 2-pin connector - 1 5A fuse - C able max. rating: 10 Amp - -40°C/-40°F low temperature use. Cable remains flexible at ‘below freezing’ temperatures Note: Includes in-line rubber seal for OptiMATE heavy duty SAE connector. 941546 OptiMATE O-14 cable OPTIMATE, BATTERY CHARGE CABLE O-01 Premium quick connect permanent battery lead for power sport batteries, with weather protected connection system and cable. - Weatherproof battery lead, powersport - Length=20″/50cm - 1/4″ / M6 ringlets - Industry standard 2-pin SAE connector - 15A fuse - Cable max. rating: 5 Amp - -40°C/-40°F very low temperature use; cable remains flexible at ‘below freezing’ temperatures Note: Rubber sealing cap & shroud for OptiMate heavy duty SAE connector 941545 OptiMATE O-01 cable OPTIMATE, BATTERY MONITOR CABLE - Micro processor driven 4 LED system used to monitor battery status. - I nforms you if the battery is in a good/needs charge/not good condition - When the engine is running it also informs you if the vehicle's charging system is working. Then the LED mode changes to an arrow, with the pointer reaching the LED matching the voltage being delivered by charging system. No arrow means there is no charge - A bright red LED warns that the charge level has reached 50% and that it is time to recharge that battery - During vehicle storage the LED matching the battery’s state of charge will blink every 5 seconds, drawing very little power (0.2 milli-amps) to do so, in fact 20-100 times less than the vehicle’s circuitry is drawing from the battery at the same time - Fast blink mode for first 15 seconds after connection to battery, for quick check of multiple batteries (e.g. vehicles on showroom floor) AGM / Lead acid batteries 941543 O-124 monitor cable. 60cm long. With M6 / 1/4" ringlets to 2-pin SAE connector with waterproof sealing cap. 4 LEDs cover ‘full to empty’ voltage range of all 12V batteries, including higher voltage AGM for power sport (4th √√ LED ≥ 12.7V 941544 O-125 monitor cable. 15cm long. Inline with 2-pin SAE to 2-pin SEA connectors with waterproof sealing cap. 4 LEDs cover ‘full to empty’ voltage range of all 12V batteries, including higher voltage AGM for power sport (4th √√ LED ≥ 12.7V Lithium batteries 941815 O -127 cable. 60cm long. With M6 / 1/4" ringlets to 2-pin SAE connector with waterproof sealing cap. OPTIMATE TEST, 'CRANKING & ALTERNATOR' TS120 BATTERY TESTER 12V professional pocket tester for on-vehicle battery cranking performance & alternator charge voltage testing. - C hecks battery charge level - Start engine. OptiMate TEST records and indicates (for 20 sec) the lowest start volts - With engine running, verify charging voltage from alternator and voltage regulator. - Microprocessor accuracy - Easy to follow instructions on rear panel of the tester - Easily connects with connect clips to the battery or to an installed SAE 2-pin battery lead. - Industry standard SAE 2-pin connector - 100cm battery clip set - Fully sealed 941489 OptiMATE TEST TS120 battery tester OPTIMATE, USB CHARGERS Fast charge 2 mobile devices at the same time. Fits into a standard BIKE power socket of BMW, Triumph or Ducati MultiStrada. - Connects to a standard BIKE (DIN Ø12mm) power socket - Weatherproof - Offers 2 x 3300mA fast charge USB power - Auto-off 3 hours after engine stopped or if battery voltage drops below 12.3V, to protect the vehicle battery 941549 OptiMATE USB O-115. Straight socket 941548 OptiMATE USB O-105. 90° angled socket OPTIMATE TEST, 'STATE OF CHARGE' BATTERY TESTER For all 12V lead-acid & 12.8V/13.2V lithium batteries. Used to quickly see the battery's charge condition before a battery is sold, or when it is returned. - State of charge result in Volts and %, 3 different bands for Lead Acid, AGM/GEL and LiFePO4 4 series batteries - Easy to follow instructions on rear panel of the tester - Easily connects with connect clips to the battery or to an installed SAE 2-pin battery lead. - I ndustry standard SAE 2-pin connector - 100cm battery clip set - Flashing indicator for discharged battery 941420 OptiMATE Test TS126 battery tester TECMATE, TESTMATE AUTO 2 BATTERY TESTER The TestMate provides within seconds a professional assessment of the state of health, state of charge and CCA capability of a 12V battery. The TestMate is compact, light, and can be used in the workshop or at the sales counter. - Professional affordable 12V battery tester - Select battery type and Ah / CCA, then TEST - For all battery technologies (Lead Acid, AGM, GEL) - Result available in seconds - Rugged, ideal for workshop use 941509 Testmate Auto 2. Up to 200 Ah batteries OPTIMATE, USB 0-100 CHARGER Combination 2400mA USB charger and 3-LED battery monitor, with vehicle battery protection. - Vehicle battery protection: USB output turns off 3 hours after engine stopped or when vehicle battery charge level is less than 50% - 3 LED battery monitor (when USB output off) – battery status is displayed every 5 seconds - 12V input through an industry standard SAE 2-pin connector - 5V 2400mA true output - Unique seal and cap design for USB socket ; use any USB cable, seals when inserted - Short circuit, overheat, over-voltage protection 941547 OptiMATE USB O-100 941549 941548 941547 941546 941545 941543 941544 941815 941509 941420 941489

RkJQdWJsaXNoZXIy ODQ0NDEw