298 V-TWIN TOOLS LOWER END JIMS, CAM BEARING REMOVER TOOL Used to easily pull the inner camshaft bearing from the case, no need to disassemble cases. Also keeps rollers from falling out of the bearing into the crankcase during removal. 978288 58-99 B.T. (excl. Twin Cam) 978291 57-90 XL, Buell 978288 GEORGE'S GARAGE, 58-99 INNER CAM BEARING INSTALLER TOOL Used to install the camshaft bearing of 58-99 B.T. (excl. TC). Note: 979461 driver handle required for installation and must be purchased separately. 979467 Installer tool 979467 JIMS, CAM BEARING INSTALLER TOOL Used to press the inner cam needle bearing smoothly and easily into the right crankcase half, with cases assembled, to the correct depth. Note: Use JIMS tool MCS 978288 to remove bearing. 978287 58-99 B.T. (excl. TC) 978287 GEORGE'S GARAGE, 58-99 INNER CAM BEARING REMOVER & INSTALLER TOOL Used to press-in install and press-out remove the camshaft needle bearing of 58-99 B.T. models (excl. TC) in a controlled action. Case disassembly is not required. 979405 Installer tool 979404 Remover tool 979405 979404 JIMS, CAM BEARING INSTALLER TOOL Used to install the cam needle bearing into the cases in combination with the 920542 installation handle. Note: MCS 920542 race & bearing installation handle is needed with this tool and must be purchased separately. 978289 58-99 B.T. (excl. TC) 978290 57-90 XL; 87-90 Buell 978289 JIMS, INNER CAM BEARING GAUGE PINS Used to check the inner size of the cam needle bearing. With not enough press-fit the cam can rock, causing noise and unnecessary cam/bearing and roller wear. Too tight bearing can damage cam and cam bearing. Sold in set of 2 (one go & one no-go pin). Quick & easy to use. 978383 58-99 B.T. (excl. TC) 978383 978285 JIMS, CAM COVER HOLDING TOOL Holds the cam cover tight and helps avoid damage or scratches when removing/installing cam bushings. Can be clamped in a workbench vise. 978285 70-99 B.T. (excl. TC) JIMS, CAM BUSHING REMOVER TOOL Removes the 512572 (25581-36) outer cam bushing in the cam cover. Removes cam cover & bushing in one operation. Also used to remove the 660-36 / 25597-36 cam bushing in the crankcase of early models. 978243 36-69 B.T. 978243 JIMS, CAM BUSHING INSTALLER TOOL Used to install the outer cam bushings on the following H-D models. Note: Cam bushings on 4-cam models are counted from rear to front side of engine. For instance #1 bushing is for rear exhaust cam. Note: #2 cam bushing installer is not available from JIMS. 978274 36-69 B.T. 978275 70-99 B.T. (excl. Twin Cam) 978277 54-22 K, KH, XL (excl. XR1200); 87-10 Buell; 37-48 74" Flathead (Installs 25586-37 outer cam bushing) 978274 JIMS, MAINDRIVE GEAR/CAM BUSHING TOOL Used to remove and install main drive gear bushings on 36-86 4-sp B.T. and also removes 70-99 B.T. cam bushing. 978268 36-86 4-sp B.T. 978268
RkJQdWJsaXNoZXIy ODQ0NDEw