300 V-TWIN TOOLS JIMS, TC CAM RELIEF TOOL - SINGLE SPINDLE Used to remove case material for larger than stock camshafts. This tool has one spindle cutter and must be re-mounted to clear the opposite cam side. Can be driven by a standard motor drill with a 1/2" chuck. 978471 99-06 Twin Cam (excl. 2006 Dyna) 978471 JIMS, TC CAM RELIEF TOOL - DUAL SPINDLE Used to remove case material for larger than stock camshafts. This tool has dual spindle cutters to reduce set-up time. Can be driven by a standard motor drill with a 1/2" chuck. 978472 99-06 Twin Cam (excl. 2006 Dyna) 978472 LOWER END JIMS, INNER CAM BEARING TOOLS Used to remove and install the inner cam bearings on Twin Cam and M8 models. Remover tool Used to remove the inner cam bearings easily without any damage to the crankcase. This precision built tool will also keep the pin rollers from accidentally falling into the crankcases. Designed similar to the Evo cam bearing tool. 978214 99-06 Twin Cam (excl. 2006 Dyna) 978483 06-17 Dyna; 07-17 Softail; 07-16 Touring Installer tool This tool will install the two inner cam bearings. It perfectly aligns to the shaft bores for a precision press fit. 978215 99-17 Twin Cam Remover & installer tool Used to remove and install inner cam needle bearing. The removal hole works as a window for better control during the process. Allows a more precise installation depth. 559400 17-22 M8 978215 978214 JIMS, CAM BEARING REMOVER TOOL Once the camshafts are removed from the support plate, this tool will remove the bearing from the camshaft. Unlike a general purpose puller this tool was designed to remove the bearing straight with no slipping or binding. 978219 99-06 Twin Cam (excl. 2006 Dyna) 978219 GEORGE'S GARAGE, CAM BEARING REMOVER TOOL Used to remove the camshaft roller bearing from the camshaft after camshafts are removed from support plate. 979412 99-06 Twin Cam (excl. 2006 Dyna) 979412 559400 MCS, INNER CAM BEARING INSTALL AND REMOVAL TOOL Used to remove & install the inner cam bearing on M8 models. Tool will prevent the pin rollers from dropping into the crankcase. The installation driver installs the cam bearing to its proper depth. 951571 18-22 Softail; 17-22 Touring 951571 MCS, INNER CAM BEARING INSTALL & REMOVE TOOL KIT Used to remove and install the inner cam bearings. The remove tool Is used to pull the inner camshaft bearings effortless from the right side crankcase on an assembled engine. Designed to prevent anything from the needle bearing falling into the crankcase. The install tool Is used to install the new inner two cam bearings. Designed to align the bearings to the bearing bores for a straight, true and smooth bearing installation. 99-06 Twin Cam (excl. 2006 Dyna) (5-speed) and 06-17 Dyna; 07-17 Softail; 07-16 Touring (6-speed) models 925532 Install & remove tool kit 925532
RkJQdWJsaXNoZXIy ODQ0NDEw