MCS Workshop Catalog by BMG

332 V-TWIN TOOLS O2 SENSOR JIMS, OXYGEN SENSOR TOOL Used to install & remove the oxygens sensor on all 06-20 H-D closed loop EFI models. Fits front & rear unless mentioned otherwise. Socket Comes with 3/8" drive, but can also be used with a regular 7/8" wrench. Socket will withstand up to 125ft/lbs torque. 978506 06-11 Dyna; 07-11 Softail; 07-09 Touring 962034 12-20 Softail (rear pipe only) Wrench Used to remove the late 12mm threaded 4-wire heated oxygen sensors. Sensor must be torqued with just 14 ft-lbs. Design can be used with a torque wrench. 961579 10-20 Touring 962033 12-20 Softail (front pipe only); 12-17 Dyna; 13-17 V-Rod 978506 961579 962033 962034 LISLE, OXYGEN SENSOR TOOLS Used to install & remove or loosen stuck oxygen sensors and restore oxygen sensor 18mm threads. 530779 7/8" socket with cutaway slot for wiring 530781 Dual drive. 3/8" for use with rachet for installing & removing and 1/2" for use with a breaker bar for loosening stuck sensors 530780 18mm O2 sensor thread chaser. Fits 06-09 Touring; 06-11 Dyna, Softail, XL, V-Rod 530779 530780 530781 JIMS, O2 THREAD CHASERS Used to clean the threads in oxygen sensor bung of the exhaust pipes. Note: Not suitable for cutting new threads. 962012 18mm. 06-09 Touring; 06-11 Dyna, Softail, XL, V-Rod 962013 12mm. 12-20 Softail; 12-17 Dyna; 10-20 Touring; 14-22 XL; 12-17 V-Rod 962012 962013 EVOLUTION INDUSTRIES, OIL FILTER WRENCH Strong one-piece construction, from one-piece aircraft quality 6061 aluminum. Will not deform and always give a good, snug fit. With cut-out to clear crank position sensor. Fits all regular 76mm oil filters with 14 flats. For 3/8" drive or 15/16" socket. 552106 Oil filter wrench 552106 JIMS, OIL FILTER CUTTER TOOL In engine troubleshooting it can be necessary to cut the oil filter for a content check. This cutter makes a clean cut around the oil filter base, up to 5-1/2" (14cm) diameter, with ease. The optional oil filter cutting stand can be mounted on a workbench or installed in a vice and will grip the oil filter tightly for a non-slip effortless cutting action. 961456 Oil filter cutter 961455 Oil filter cutting stand 961456 961455 Oil filter content inspection 910503 910510 OIL FILTER WRENCH Fits all 76mm spin-on type oil filters with 14 flats. Enables you to remove the oil filter without force. With or without crank position sensor cut-out. With 3/8" drive. Standard 910503 Zinc plated 910510 Black With crank position sensor cut-out With cut-out to clear crank position sensor on Twin Cam models. 910641 Zinc plated 910640 Black 910640 910641 JIMS, OIL FILTER WRENCH Fits all 76mm oil filters with 14 flats. Use with 3/8" square drive. 978475 Filter wrench 978475 OIL FILTER

RkJQdWJsaXNoZXIy ODQ0NDEw